1. PREPARATION

•   • Make sure the device is turned off, and if possible, remove the battery before
    installation.

•   • Wash your hands and dry them before handling any DesignSkin Pieces.

•   • Clean the device with a lint-free cloth removing any dirt, grime, or fingerprints.
• 
    • Identify the DesignSkin Pieces and where they fit by comparing to the device.

•   • Apply DesignSkin Pieces to the device, adhesive side down and using a credit
    card or hard plastic card, push bubbles away from center of the film towards
    the edges.

•   • Set the device down onto a heat-resistant surface. Set your blow dryer or heat
    gun on medium heat (or low if it only has 2 settings), with the blowing power on
    low.

•   • Point the warm air towards the parts of the skin that are peeling off the device.
    Wait until the skin is slightly softer before tacking it onto the device.

•   * The heat will activate the adhesive properties of the film and allow it to adhere
    completely. Please use caution during this step. Avoid exposing your device to
    excessive heat.

• 
    • Identify Clear TechSkin™ Pieces and where they fit by comparing them to the
    device.
• 
    • With wet fingers, remove the TechSkin™ from backing paper and spray adhesive
    side with the solution. Do not let the film stick to anything that is not wet.
• 
    • Apply TechSkin™ pieces to the device, with the adhesive side facing down. Align
    the film using any holes, logos and buttons as a guide. Apply the skin starting
    one side to the other side.
• 
    • Wrap a credit card or hard plastic card in the included microfiber cloth and gently
    push the excess solution and bubbles away from the center toward the edges of the
    film. AVOID pushing the solution and bubbles into any holes, speakers or buttons
    on the device.
  
  3. PERFECTION
  
  
  •   • Please allow a few hours for the film to set and at least 4-5 hours before
      powering on your device.
  
  
  •   • You can use a hair dryer, on low-setting, to quicken the process and help the film
      set faster.
  
  
  •   • Micro-bubbles, streaks, and imperfections will disappear within 2-3 days.

•   • Find a suitable corner on the device to begin removing the film.

•   • Apply low heat to the selected corner for about 10 seconds. Begin by carefully
    lifting the edge of the film away from the device.

•   • Support the device with your other hand close to the area where you are removing
    the film. This may take some time on larger devices as TechSkin is extremely tough
    and durable.

•   * Tip – For best results use a hair dryer on “low” setting to aid in the removal
    process.

•   • Slowly peel back the film while adjusting your grip to be closer to where the film is
    being removed. Check the film every few centimeters. Continue to apply low heat to
    the areas that are still adhering to the device and peel slowly and carefully until 30%
    of the film is removed.

•   WARNING - Never apply heat from sources such as an open flame, butane
    torches, or settings higher than “low” on your hair dryer.

•   • Select a different corner of the device and repeat steps 2 and 3 until the film is
    completely off of the device.